Cavity Wax
    Gravel Guard
    Sprayable Seam Sealer
    Heavy Duty Coating

    Trim Masking Tape
    Perfection Masking Tape
    Parking Sensor Protectors
    Fine Line Tape
    Fine Line Striping Tape
    Soft Edge Foam Tape
    Fleece Wire Harness Tape

    Aerosol Spray Wands
    Air Drying Equipment
    Caulking Guns
    Decal Eraser Wheel
    Digital Tire Inflator/Deflator
    Engine Cleaning Guns
    Foam Guns
    Infrared Parts
    Spot Weld Cutter Sharpener
    Seam Sealer Gun
    Spray Guns
    Undercoating Guns
    Universal Coupler

rust proofing spray gun

The Pro Gun builds up pressure inside the tank. This pressure allows for the spraying of thicker products and assures that the rust proofing product is atomized at the tip of the wand to provide total coverage inside the cavity. The gun is recommended for both solvent based and waterborne coatings.

This metal gun was built for industrial use by body shops, car dealerships and undercoating professionals yet it can easily be used by any hobbyist or do-it-yourselfer.

Assembled with the undercoating spray cap attached. It can be easily changed to spray cavity wax by changing this spray cap to the quick coupler and attaching the spray nozzle or wands (all included). The mist wand is 5 ft long, the hand held (90) wand is 30 inches long.

Please note that some bed liners/floor coatings contain silica or rubber particles to prevent sliding. These coatings can not be sprayed with the Pro Gun.

The Rustproofing wands included with the Pro Gun are for lighter coatings, i.e., cavity waxes and protective oils and can not be used to spray under coatings. We offer an optional Undercoating wand (Item BS 39). Order the Pro Gun Plus if you want to purchase the additional wand.

  • Nickel plated brass body
  • Aluminum tank
  • Stainless steel needle
  • Tank capacity: 1 liter
  • Air consumption: 7 - 10 CFM
  • Working pressure: 40 - 60 PSI
  • Weight: 1.07 kg (2.36 lbs)
  • All parts available
  • Made in Italy
  • Product ID: UCPRO, UCPRO+

This product is now available for online purchase. For model UCPRO click here. For model UCPRO+ click here.


Upon finishing the task at hand, purge left over product from the wands by pulling the trigger half way. Rinse wand with solvent/water to dissolve product left inside the wands. Always check the MSDS and tech sheets supplied with the product sprayed to make sure you are using an appropriate cleaner.


When spraying cleaning solvents with the gun, ALWAYS close the Air Control Knob (BS19) first. Atomized solvents are extremely flammable. Properly dispose of cleaning solvents as per local regulations.

included wands

Operating Instructions for Undercoating/Rustproofing Gun (UCPRO)

  CHEMICARusa 670 New York Street, Memphis, TN 38104 USA • toll-free 800.261.7976 • fax 901.274.8816 • Info
Privacy Policy