Cavity Wax
    Gravel Guard
    Sprayable Seam Sealer
    Heavy Duty Coating

    Trim Masking Tape
    Perfection Masking Tape
    Parking Sensor Protectors
    Fine Line Tape
    Fine Line Striping Tape
    Soft Edge Foam Tape
    Fleece Wire Harness Tape

    Aerosol Spray Wands
    Air Drying Equipment
    Caulking Guns
    Decal Eraser Wheel
    Digital Tire Inflator/Deflator
    Engine Cleaning Guns
    Foam Guns
    Infrared Parts
    Spot Weld Cutter Sharpener
    Seam Sealer Gun
    Spray Guns
    Undercoating Guns
    Universal Coupler

Undercoating Gun Professional Grade Spray
Gun designed for spraying undercoating, protective waxes, soundproofing and gravel protection. This gun is hermetically sealed which prevents the product from hardening during work breaks.

The BS under coating spray gun features three adjustments: air flow, product flow, and product atomization allowing the user to recreate a wide variety of patterns and textures. Supplied with a set of spray wands to apply wax based rustproofing in doors, cavities, beams etc.

An optional undercoating wand is available for application in hard to reach places, i.e. around mufflers, exhaust pipes, etc.

  • Nickel plated brass body
  • Aluminum tank
  • Stainless steel needle
  • Set up to spray 1 Liter cans, USA quart cans (BS/A USA) or loose fill
  • Approximate air consumption: 200-300 L/min (7-10 CFM)
  • Working pressure: 3-4 bar (max. 10 bar) 40-60 psi (max. 140 psi)
  • Weight: 1.6 kg/4 1/2 lbs.
  • Made in Italy
  • Product ID: BS/A WB
Spray Wands
Rust Proofing Wands
Rust Proofing Rust Proofing Wands
The BS/A is delivered with 3 rust proofing wands as standard equipment. These wands are to be used with wax-based rust proofing only.

BS36 Wand BS38 Wand
BS36 Mist Wand
90 degrees for spraying inside cavities
BS38 Mist Wand
180 degrees for spraying inside cavities
BS37 Hand Held Applicator
for hard to reach places

Undercoating Wand
Undercoating Wand The BS/A wb can be equipped with the optional Undercoating Wand (item # BS39). This allows for spraying of Undercoating in hard to reach places behind mufflers, exhaust pipes, etc.

Wand Installation
To install the wands:
1. Close the air regulator on top of the tank (BS45) (BS/A WB Model Only)
2. Remove the sprayhead cap (BS02)
3. Attach the desired wand to sprayhead (BS03)
4. Open air control knob (BS19)
5. Adjust product flow as needed by turning product flow control knob (BS09)

Wand Cleaning
Purge all product from the wand by pulling the trigger halfway
Rinse the wand with a solvent/water to dissolve the product left inside.

When spraying cleaning solvents with the gun, ALWAYS close the Air Control Knob (BS19) first. Atomized solvents are extremely flammable. Properly dispose of cleaning solvents as per local regulations.

Operating Instructions for Undercoating Gun (BS/A WB)
Operating Instructions for Undercoating Gun (BS/A USA, BS/A SC)

  CHEMICARusa 670 New York Street, Memphis, TN 38104 USA • toll-free 800.261.7976 • fax 901.274.8816 • Info
Privacy Policy