How to Apply TK44 Undercoating

START BY APPLYING TK44 UNDERCOATING TO A CLEAN SURFACE

Surfaces to be treated must be clean, dry, rust, dust-and grease free.
New vehicles; wash undercarriage with a degreaser to ensure no oils, grease, release agents, etc. are left from the assembly process.
Used vehicles; should be thoroughly cleaned to remove mud, sand, salt and road grime.
Use a power washer and top quality degreaser for the best results.
Let vehicle dry before application.

Shake before use.
Product can be applied by light airless equipment, but also by an air mix pistol with an air-pressure of 3-6 bar / 45 to 90 psi.
Optimum spraying distance is about 1 foot.
Depending on the application, the product can be thinned using mineral spirits or white spirits.
Spray the surface with undercoating until the desired layer thickness is reached.
If thicker layers are wanted, it is recommended to dry the layers in between.
Overspray, or equipment contaminated with overspray, must be cleaned while still wet with mineral spirits or white spirits.
Keep in mind that the wheel wells are exposed to abrasion from rocks, sand, salt, etc. and may need a thicker coat than the undercarriage.
If thicker layers are needed, allow a 3 hour flash off between layer applications.

The product may not be stored under +10°C / 50°F and above +30°C / 85°F.
Product must be protected from direct sunlight and heat.
When stored in a cool, dry and well-ventilated area, the product has a shelf life of 2 years in unopened, original packaging.
See MSDS for the latest safety precautions.